This is a working overview of MC4R, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-10-08 and is reviewed periodically as new material appears.
Lyophilised peptide is generally held below minus twenty degrees Celsius, protected from light and moisture, because hydrolysis and oxidation accumulate faster at ambient temperature. Once reconstituted, solutions are typically kept between two and eight degrees Celsius and used within a short window defined by the supplier. Repeated freeze-thaw cycles are avoided since they promote aggregation and loss of soluble material. Container material matters as well, because peptides adsorb to certain plastics and glass surfaces at low concentration. Stability figures supplied by a vendor apply only to the specific lot and buffer that were tested.
Identity and purity are usually established with reversed-phase high-performance liquid chromatography combined with mass spectrometry. A gradient of water and acetonitrile containing trifluoroacetic acid is a common mobile phase, and ultraviolet detection near 214 nanometres responds to the peptide backbone. Mass spectrometry confirms the expected molecular mass and helps reveal truncation or oxidation products. Purity is reported as a peak-area percentage, a figure that depends on the wavelength and gradient used, so values from different laboratories are not always directly comparable. Peptide mapping and amino acid analysis provide additional confirmation when required.
Regulatory status varies by jurisdiction, where approved prescription products, compounded preparations and research-grade material are treated as distinct categories with different documentation requirements. Suppliers of research material commonly issue a certificate of analysis listing purity, identity and sometimes endotoxin content. Independent verification by a third-party laboratory is often recommended because self-reported figures are difficult to check. Literature discussions usually state the source, purity and storage conditions of the material used, since these details affect reproducibility. Analysts note that a reported purity figure does not by itself describe biological activity.
Melanocortin receptors form a family of five G-protein-coupled proteins, labelled MC1R through MC5R, that respond to peptides derived from pro-opiomelanocortin. Alpha-melanocyte-stimulating hormone and adrenocorticotropic hormone are the best-known endogenous ligands. The receptors are distributed differently across tissues, so a single agonist can produce effects in the brain, skin, adrenal gland and vasculature. This distribution explains why one peptide can influence both pigmentation and motivated behaviour.
Bremelanotide is a cyclic heptapeptide that binds several melanocortin receptors rather than one. In vitro assays report agonist activity at MC1R, MC3R, MC4R and MC5R, with MC4R generally treated as the subtype most relevant to sexual effects. MC4R is expressed in hypothalamic nuclei involved in appetite, energy balance and motivated behaviour, which provides a plausible route for central action. Selective MC4R agonists studied in animals produce comparable behavioural changes, supporting that interpretation.
How receptor activation translates into a change in desire is not established in detail. Proposed steps include modulation of dopaminergic signalling in reward circuits and downstream effects on autonomic tone. Human data consist mainly of clinical trials measuring self-reported outcomes rather than direct measurements of brain activity or transmitter release. The transient rise in blood pressure sometimes observed after administration is likewise reported consistently but explained only partly by known melanocortin pathways.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised solid before reconstitution |
| Solubility class | Soluble in water and aqueous buffers | Stock solutions often prepared in sterile water |
| Typical storage temperature | Minus twenty degrees Celsius or below | Dry powder, protected from light |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Ultraviolet detection near 214 nanometres |
| Common synonyms | PT-141 and bremelanotide | Code and generic name used interchangeably |
Lyophilized peptide arrives as a white to off-white cake or powder and is normally held at minus twenty degrees Celsius or colder for extended periods. Short-term bench work at ambient temperature is tolerable for minutes, not hours, because the solid is hygroscopic and picks up moisture that promotes hydrolysis. Vials should stay in a desiccator or a sealed bag with desiccant, protected from light, since aromatic residues in the sequence are susceptible to photo-oxidation. Inventory records that note arrival date and storage location reduce the chance of using degraded material.
Reconstitution is usually performed with sterile water or a dilute acetic acid solution, and the choice of solvent affects both dissolution speed and final pH. Complete dissolution should be confirmed by visual inspection before any aliquot is taken, since undissolved particles can concentrate in the sampling volume. Repeated freeze-thaw cycles are the most common cause of gradual loss of purity, so dividing a stock into single-use aliquots at the first opportunity is standard practice. Working solutions kept refrigerated are generally used within days rather than weeks.
Bremelanotide is a synthetic cyclic heptapeptide developed under the research code PT-141. The code reflects its position in an internal compound series rather than a chemical classification, and the name bremelanotide was later adopted for regulatory filings. Structurally it belongs to the melanocortin peptide family and shares a core sequence motif with alpha-melanocyte-stimulating hormone. The compound is supplied as an acetate salt in aqueous solution for injection. In reference literature it is indexed under both the code and the generic name, a dual listing that can complicate database searches.
Early work on melanocortin analogs in the 1980s and 1990s produced peptides intended to influence pigmentation and appetite. One of these, melanotan II, was observed to affect sexual desire as an incidental finding in self-administration reports. Researchers then pursued analogs with altered receptor selectivity and improved handling characteristics, and PT-141 emerged from that program in the late 1990s. The development path moved from dermatology and metabolism toward a central nervous system application, a shift that shaped both trial designs and the eventual label.
As there are two carbon atoms available for substitution, β-amino acids have four sites (chirality included; as opposed to two in α-amino acids) for attaching the organic residue group. Accordingly, two main types β-amino acids exist differing by which carbon the residue is attached to: ones with the organic residue (R) next to the amine are called β3 and those with position next to the carbonyl group are called β2. A β-peptide can consist of only one kind of these amino acids (β2-peptides and β3-peptides), or have a combination of the two. Furthermore, a β-amino acid can form a ring using both of its sites and also be incorporated into a peptide. β-Amino acids have been prepared by many routes, including some based on the Arndt-Eistert synthesis.
Amino acids are organic compounds that contain both amino and carboxylic acid functional groups. Although over 500 amino acids exist in nature, by far the most important are the 22 α-amino acids incorporated into proteins. Only these 22 appear in the genetic code of life. Amino acids can be classified according to the locations of the core structural functional groups (alpha- (α-), beta- (β-), gamma- (γ-) amino acids, etc.); other categories relate to polarity, ionization, and side-chain group type (aliphatic, acyclic, aromatic, polar, etc.). In the form of proteins, amino-acid residues form the second-largest component (water being the largest) of human muscles and other tissues. Beyond their role as residues in proteins, amino acids participate in a number of processes such as neurotransmitter transport and biosynthesis. It is thought that they played a key role in enabling life on Earth and its emergence. Amino acids are formally named by the IUPAC-IUBMB Joint Commission on Biochemical Nomenclature in terms of the fictitious "neutral" structure shown in the illustration. For example, the systematic name of alanine is 2-aminopropanoic acid, based on the formula CH3−CH(NH2)−COOH. The Commission justified this approach as follows:
Enteroglucagon is a proglucagon-derived peptide or enteroendocrine cells derived peptide in the small intestine. Preproglucagon undergoes post translational modification to release glucagon-like peptides (GLP-1 and GLP-2) and other molecules derived from L-cells of intestine. GLP-1 is derived from a class of intestinal hormones called incretin and the molecule exists in two forms GLP-1(7-37) and GLP-1(7-36) amide. GLP-1 form of incretin starts circulating in response to a high blood glucose level. Incretin effect is a negative feedback loop between glucose and insulin level, it promotes insulin release from beta cells of pancreas islet and suppresses glucagon when the glucose level is high. In vertebrate mammals, GLP-2 sequences are highly conversed in the intestine. The molecule functions as a part of adaptive response, such that contributes intestinal growth, proliferation effect, intestinal dilation (increases the mucosal blood flow) and reduces the chance of apoptosis.
Sources: en.wikipedia.org
Outer membrane proteins are membrane proteins with key roles associated with bacterial cell structure and morphology; cell membrane homeostasis; the uptake of nutrients; protection of the cell from toxins including antibiotics; and virulence factors including adhesins, exotoxins, and biofilm formation. There are a number of outer membrane proteins that are specifically virulence-related. Outer membrane proteins consist of two major classes of protein - transmembrane proteins and lipoproteins. The transmembrane proteins form channels or pores in the membrane called porins, and actively pumping efflux channels. The outer membranes of a bacterium can contain a huge number of proteins. In E. Coli for example there are around 500,000 in the membrane. Bacterial outer membrane proteins typically have a unique beta barrel structure that spans the membrane. The beta barrels fold to expose a hydrophobic surface before their insertion into the outer membrane. Beta barrels vary in sequence and size that ranges from 8 to 36 beta strands. A subset of OMPs have a perisplasmic or an extracellular link to their beta barrel structure. An outer membrane protein is translocated across the inner membrane through Sec machinery, and finally inserted to the outer membrane by the barrel assembly machinery complex.
The catalytic mechanism of FGE is well studied. A multistep redox reaction with a covalent enzyme: substrate intermediate is proposed. The role of the cysteine residue for the occurring conversion was studied by mutating the cysteine to alanine. No conversion was found using mass spectrometry when the mutated peptide tag was used. The mechanism shows the important role of the redox active thiol group of cysteine in the formation of f(Gly), as seen in Fig. 2. The key step of the catalytic cycle is the monooxidation of the cysteine residue of the enzyme, forming a reactive sulfenic acid intermediate. Subsequently, the hydroxyl group is transferred to the cysteine of the substrate and after hetero-analogous β-elimination of H2O, a thioaldehyde is formed. This compound is very reactive and easily hydrolyzed, releasing the aldehyde and a molecule of H2S,
MT-ND6 interacts with the NADH dehydrogenase [ubiquinone] iron-sulfur protein 3 (NDUFS3) and the ATP-dependent metalloprotease YME1L1. Mass spectrometry characterization of MT-ND6 at COPaKB GeneReviews/NCBI/NIH/UW entry on Mitochondrial DNA-Associated Leigh Syndrome and NARP This article incorporates text from the United States National Library of Medicine, which is in the public domain.
Sources: en.wikipedia.org
Mycosporine-like amino acids (MAAs) are small secondary metabolites produced by organisms that live in environments with high volumes of sunlight, usually marine environments. The exact number of compounds within this class of natural products is yet to be determined, since they have only relatively recently been discovered and novel molecular species are constantly being discovered; however, to date their number is around 30. They are commonly described as "microbial sunscreens" although their function is believed not to be limited to sun protection. MAAs represent high potential in cosmetics, and biotechnological applications. Indeed, their UV-absorbing properties would allow to create products derived from natural photoprotectors, potentially harmless to the environment and efficient against UV damage.
Artificial white blood cells are typically membrane bound vesicles designed to mimic the immunomodulatory behavior of naturally produced leukocytes. While extensive research has been done with regards to artificial red blood cells and platelets for use in emergency blood transfusions, research into artificial white blood cells has been focused on increasing the immunogenic response within a host to treat cancer or deliver drugs in a more favorable fashion. While certain limitations have prevented leukocyte mimicking particles from becoming widely used and approved by regulatory bodies (e.g., US FDA, EU EMA, UK MHRA, JP PMDA, AU TGA), more research is being allocated to this area of synthetic blood which has the potential for producing a new form of treatment for cancer and other diseases.
β-pleated sheet structures are made from extended β-strand polypeptide chains, with strands linked to their neighbours by hydrogen bonds. Due to this extended backbone conformation, β-sheets resist stretching. β-sheets in proteins may carry out low-frequency accordion-like motion as observed by the Raman spectroscopy and analyzed with the quasi-continuum model. A β-helix is formed from repeating structural units consisting of two or three short β-strands linked by short loops. These units "stack" atop one another in a helical fashion so that successive repetitions of the same strand hydrogen-bond with each other in a parallel orientation. See the β-helix article for further information. In lefthanded β-helices, the strands themselves are quite straight and untwisted; the resulting helical surfaces are nearly flat, forming a regular triangular prism shape, as shown for the 1QRE archaeal carbonic anhydrase at right. Other examples are the lipid A synthesis enzyme LpxA and insect antifreeze proteins with a regular array of Thr sidechains on one face that mimic the structure of ice.
Sources: en.wikipedia.org
Purity is normally expressed as a percentage of total peak area from a chromatographic run. The value depends on the column, gradient and detection wavelength chosen. Results generated under different conditions are therefore not always interchangeable.
Cycling between frozen and thawed states promotes aggregation and can reduce the amount of soluble peptide. Adsorption to container walls also removes material from solution over time. Suppliers generally recommend aliquoting before freezing to limit the number of cycles.
A typical certificate lists lot number, appearance, purity by chromatographic area, identity confirmation and the analytical methods used. Some suppliers add endotoxin or residual solvent results. The document describes the tested lot only and does not extend to other batches.
Bremelanotide binds several melanocortin receptors, and MC4R is the subtype most often cited as responsible for its behavioural effects. Activity at MC1R, MC3R and MC5R is also reported. Selectivity is therefore described as limited rather than precise.